RS246.com Forum :: The World's #1 Audi R, S and RS Enthusiast Community

Hi All,

Getting Wagner ICs fitted and cannot decide on...

1. Fog delete
2. Keep fog frame (as per Wagner website - http://www.wagner-tuning.co.uk/audi-rs6 ... b-41-p.asp)
3. Maintain OEM look

What do you guys think?

R

Maintain OEM look.

Yes keep the fog lights as in OEM look

Is there a plug for the tow eye access?

Don't know TBH sorry

amanda1 wrote:Yes keep the fog lights as in OEM look

+1

el_ringo wrote:Is there a plug for the tow eye access?

Yes, included.

Are you getting this done from MRC? Take a look at a couple of C5s at MRC currently with Wagners and foglight delete, it looks horrid IMO. You can still see the foglight strut, I'd say it's probably retained for lower lip strength.

Grizz is fitting them. I think keeping the OEM look is my favorite option, yet to see a good non OEM look for that area yet.

dont know the gain (cooling that is...) you get when deleting the froglights...think its questionable imo..

Did you plump for the carbon shrouds too?

I thought the carbon shrouds were a waste of money so I didn't bother. The gains from foglight delete were quoted at 2-3HP IIRC.

Mr Footlong wrote:Did you plump for the carbon shrouds too?

I didn't check, I guess the kit comes with it but will fire off an email to be sure.

Keihin wrote:

el_ringo wrote:Is there a plug for the tow eye access?

Yes, included.

Well mine was fitted by unit 20 and I haven't got one! Are you 100% certain it is included?

I always thought that hole was their to stop it fouling the pipework behind? Not saying I am right as I have no actual clue about if the carbon shroud fouls there. makes sense about the towing eye now that I look at it. A plug for that dirty hole would be good tbh .