RS246.com Forum :: The World's #1 Audi R, S and RS Enthusiast Community

im off to mrc for my first health check,and to book its second cambelt change,im thinking of a remap and miltek, should i or keep it 100% standard????

doug may put a map on it for you to try and if you like it buy it,if not no worries.

that would be good,,is there a big difference in performance,there pretty quick standard....wot about increase wear on the engine..

Engine wear is no more if you drive it normally, only when you give it 100% is the engine taking more toll than usual. No difference in every day driving.

If u want a standard car then leave it and if u want more power stuff then go for it. Should be worth it i am getting some remaps done soon and the guys are saying its worth every penny

cheers chaps

jaqsey wrote:cheers chaps

Standard V's generic stage 1 map..

remap a must!!!

RS4KILLA wrote:remap a must!!!

ditto that!

even your fuel econ gets better

nice one drjones. looking good ,may have to invest

jaqsey when you going to mrc? i'm nipping in tomorrow to have a couple of fault codes sorted!

im in saturday morning,as m new to an rs4,imtrying to get all these fault code problems?(any one tell m about them)
should be a crack ,m40 givng it some!

Get the remap there nothing special std but mapped they are!

Get the remap there nothing special std but mapped they are!