RS246.com Forum :: The World's #1 Audi R, S and RS Enthusiast Community

Jon_J wrote: ↑

Sun Feb 17, 2019 9:56 pm

What was your car? I’m after the headlight level sensor.

Hey Jon
It was a B7 RS4

Hi all Now that I have sold my car, for sale are the 20" RS5 Rotor ET26 wheels i had fitted to the car. They are all wearing Vredestein Ultrac Vorti 265/30 ZR20 94Y XL tyres. Two of the tyres are new and haven't been used on the road, the other two tyres have in excess of 7mm tread still on them. Th...

The time has come to sell my Daytona Grey 2007 B7 RS4 Avant. Ive owned this car since February 2012. Current mileage is approaching 109k. MOT Due 9 April 2019 Need to sell as the Mrs need an automatic for health reasons. Clutch and Flywheel has been replaced at the start of 2018. Factory equipment i...

Hi all For the last few days my EML light has come on. I reset it, thinking it may have been a random occurrence. Anyway the fault is back. Done a scan on VCDS and its showing fault on the lambda on both banks: Address 01: Engine Labels:. 079-910-560-BNS1.lbl Part No SW: 8E1 910 560 HW: 8E1 907 560 ...

Got a chance to do some testing on the lights themselves. The lights themselves actually work. I think the one of the error canceller may have a fault. Might be repairable for someone. Took some pics of the lights powered up, the reverse on these is a standard bulb. Apologies for the crap picture qu...

Intake has everything needed to fit it. The only thing you need will be two hose clamps (jubilee clips) for the hoses that attached to the red intake pipe.
More pics of the intake: Prit

Hi All Selling my Revolution Carbon Intake Went back to the standard setup over two years ago and this has been sitting in my garage ever since. Did approx 5k miles on the car. Kit is in good condition This kit retails at £599 new, asking £375 delivered SOLD IMG-20180128-WA0007.jpg Also have Dectane...

http://forum.rs246.com/viewtopic.php?f=35&t=120160 Check out this thread from when I had my drivers bolster renewed. It's pretty straight forward and took about 4 hours. Mart. That looks good, how much did they charge? Is there anyone recommended around the High Wycombe / Windsor areas that could d...

Lady Penelope wrote:Sent you PM

Didnt receive anything - could you send again please

Hi all

My drivers seat bolsters have developed rip through wear

Short of ordering replacement covers from Audi at silly prices, has anyone got theirs repaired to a decent standard?

Thanks
Prit

I have a non-res AWE Tuning ca back system on my 4. Much better built than the Milltek and sounds much better too imo

Vid of the system i made a few nights ago
https://youtu.be/TucZejY2ECQ

Run the car for a short while, the turn it off, and have a listen around the manifold for a hiss.

The solid fuel lines run under the inlet manifold and they can start to leak under pressure from the crappy fuel rail unions

The wheels came with some plastic ones which i'll use for the moment. Will machine some ally ones when have more time.

Dont mean to hijack the thread, but i will be putting my 20" rotors tomorrow.

Did you use the standard wheel bolts or got some longer ones? Im not using spacers.

Prit

How did you fix this? I have the same problem. Did you buy new fuel lines Do you have part numbers available