RS246.com Forum :: The World's #1 Audi R, S and RS Enthusiast Community

Just had the timing belt, idlers, tensioner, thermostat and water pump replaced today (£1200) hoping it was the timing that was out...... The dreaded management light went off after resetting, half a mile down the road, its back with avengence!!! THE FAULT IS STILL ON!!!

I recently had my gear box rebuilt and soon after the engine management light popped on with fault code: 17748 P1340 001 Camshaft Position Sensor-G40, Engine Speed Sensor-G28 Incorrect allocation. My local non specialist garage checked the wiring at the back of the engine, all correct, are now buffl...

MTM TCU chip was going strong at 112,000 had a service, ATF and filter change sump not properly tightened, all oil pissed out 300 miles later, gearboxed packed up today. No warning lights.

Hi Guys, Thanks for all your replies, i had the car diagnised again and its the original cylinders 3 and 7 misfiring again. I will go with the spark plugs for now although they were changed less than 500 miles ago. The plugs were laser platinums, main dealer supplied with chasis number reference. Co...

Hi, i have a 2003 RS6 Avant with a 512 bhp MTM upgrade and a full Milltek non-resonated exhaust. It recently developed a misfire problem under load in cylinders 3 and 7, i had the coil packs replaced and this cured the problem. Two days later the problem is back again this time cylinders 3 and 4, sa...

Hi i recently bought a 2003 RS6 Avant with a 512 BHP MTM upgrade.. nice and fitted a full Milltek non-resonated exhaust from the CATs to the back box. Unfortunately it has developed a misfire problem under load. Plugged up to the diagnostics it showed failure in cylinders 3 and 7. These had there co...